Error
  • JFTP::write: Bad response
  • JFTP::write: Bad response
  • JFTP::write: Bad response
ico Block Lock 360 for curved walls

 

1 Check that there is 90 angle between the floor and the wall
line
2 Apply Block Lock glue in the middle of the wall profile (D) and the horizontal profile (A). Attach these to the wall and to the floor and then apply Block Lock glue on the upper side of the horizontal profile and 20cm up on the wall profile.

line
3 Place the first glass block and attach to it the short vertical profile (B) and horizontal profile (A)
line

4

Apply Block Lock glue on the upper side of the horizontal profile and 20cm up on the vertical profile.
line
5 Place next glass blocks repeating steps 3 and 4.  Attach the vertical profiles (B) and (C) alternately.
line
6 Apply the BLOCK LOCK glue and attach the horizontal profiles (A) over the first layer of glass blocks.
line

7

Apply the BLOCK LOCK glue on the horizontal and 20 cm up on the vertical profiles. Place the next layer of glass blocks by sliding them in between the profiles.
line
8 Continue with the next layer. Attach the vertical profiles (C) in the where required places. Finish the layer repeating step 6.
line
9 Continue with the next layer. Attach the vertical profiles (B) in the where required places. Finish the layer repeating step 6
10 Apply the BLOCK LOCK glue on the horizontal and on the vertical profiles. Place the last layer of glass blocks by sliding them in between the profiles
11 After the wall has dried for approximately 24 hours, grout the wall with Block Lock grout or any other grout for glass blocks.
12 The standard Block Lock 360 Sets for 25 glass blocks can be easily combined to bigger walls.