ico Block Lock System for straight walls
 

 

 
  blocklock_montering_01   Check that there is a 90° angle between the floor and the wall.  
      line  
  blocklock_montering_02   Apply Block Lock glue in the middle on a floor profile and a wall profile.
Attach these to the floor and to the wall, and then apply Block Lock glue on the upper side of the floor profile and 20 cm up on the wall profile.

 
      line  
  blocklock_montering_03   Place the first glass block  
      line  
 

blocklock_montering_04

  Apply Block Lock glue on a vertical 18 cm profile on both sides  
      line  
  blocklock_montering_05   Place the vertical profile on the glass block. Repeat steps 4, 3 and 5.  
      line  
  blocklock_montering_06   Apply Block Lock glue on a horizontal profile and place it over the first layer of glass blocks.
 
      line  
 

blocklock_montering_07

  Continue with the next layer. Assemble 5-6 layers and leave them to dry. Continue with assembly after 24 hours.  
      line  
  blocklock_montering_09   After the wall has dried for approximately another 24 hours, grout the joints with Block Lock glass block grout in any colour of your choice.  
      line  
  blocklock_montering_10   Now your wall is finished. If you didn’t choose end blocks to end your wall, you can finish the wall with U-profiles or glass plates.
 

mini ico Download pdf